• Low VOC <5gm/L – Water Based Formula

• Safe for Food Preparation Areas – NanoPlus Formula

• Used & Trusted by Professionals – The Gold Standard

• RapidSeal Formula to provide stain resistance in 4 hours

• Maximum Stain Resistance Against Oil, Food and Grime

• Natural Look – Non Yellowing – Non Coating – Non Toxic

• Reduces Freeze/Thaw Damage, Spalling and Efflorescence

• Inhibits Mould and Mildew – Ideal To Use As A Pre-Sealer

• For Indoor, Outdoor, Domestic and Commercial Applications

AVAILABLE SIZES:

• 250ml • 1 litre • 4 litre • 15 litre •  20 litre

DESCRIPTION:

USE:

TEST FIRST:

PRECAUTIONS & SAFETY DIRECTIONS: 

1. Read entire label, SDS and technical bulletin before using;  
2. Wear appropriate gloves, skin and eye protection;  
3. Use when surface temperature is between 4°C & 32°C;
4. Surface must be clean, dry and free from sealers and coatings;
5. Do NOT allow sealer to drip or leave drip marks on the surface;
6. Do NOT use on the underside of the tile or stone. If six sided/dip sealing is required, then use Ultra-Block;

PREPARATION OF SURFACE:

INSTRUCTIONS – PRE-SEALING:

1. Pre-seal surface before installing or 24 hours after installation
2. Do NOT saturate the open grout joints; 
3. Allow minimum 24 hours cure time before grouting;
4. If using dark or contrasting grout, apply Grout Release Pro after AQUA-SEAL GOLD+® has cured, then grout as usual.

INSTRUCTIONS – SEALING:

1. Apply sealer to clean, dry surface using a sealer applicator, pump sprayer, sealer sponge, brush, paint roller or paint pad;
2. Ensure even coat & coverage then work product in thoroughly;
3. After 5-10 minutes, wipe the surface COMPLETELY DRY with absorbent paper or cotton towels to remove any excess;
4. DO NOT ALLOW PRODUCT TO DRY ON THE SURFACE;
5. Repeat this process for each application;

APPLICATION NOTES:

1. For vertical surfaces apply bottom to top and avoid rundown;
2. Porous surfaces will require additional coats. If 2 or more coats are required, allow minimum 30 minutes between coats; 
3. 2 hours after final coat, do a test to determine if surface is properly sealed. Apply some water droplets. If water is easily absorbed then apply an additional coat. Wait 2 hours and repeat the test. 
4. The surface is ready for light traffic after 2 hours. Keep dry for  minimum 12 hours.  Full cure in 24 hours.

LIMITATIONS:

EXPECTED WEAR:

COVERAGE: